TEA1507各脚功能

TEA1507各脚功能;

1 VCC supply voltage

2 GND ground

3 CTRL control input

4 DEM input from auxiliary winding for demagnetization timing, OVP and OPP

5 Isense programmable current sense input

6 DRIVER gate driver output

7 HVS high voltage safety spacer, not connected

8 DRAIN drain of external MOS switch, input for start-up current and valley sensing

UC3842各脚功能;

1 COMP This pin is the Error Amplifier output and is made available for loop compensation.

2 VFB This is the inverting input of the Error Amplifier. It is normally connected to the switching power supply output through a resistor divider.

3 ISENSE A voltage proportional to inductor current is connected to this input. The PWM uses this information to terminate the output switch conduction.

4 RT/CT The oscillator frequency and maximum Output duty cycle are programmed by connecting resistor RT to Vref and cpacitor CT to ground. Operation to 500kHz is possible.

5 GROUND This pin is the combined control circuitry and power ground.

6 OUTPUT This output directly drives the gate of a power MOSFET. Peak currents up to 1A are sourced and sunk by this pin.

7 VCC This pin is the positive supply of the control IC.

8 Vref This is the reference output. It provides charging current for capacitor CT through resistor RT.

TEA1507各脚功能

TEA1507

1.电源 2. 接地 3.控制输入 4.退磁/过压/过载保护 5.电流检测输入

6.接开关管栅极 7.高电压隔离区(空脚) 8.接开关管漏极

3842

1.误差信号补偿 2.反馈输入 3.开关管电流检测 4.外接定时元件 5.接地

6.接开关栅极 7.电源 8. 5V基准电压

tea1507维修资料TEA1507各脚功能

电源块TEA1507P用什么能代替

刚修了一个飞利浦17的彩显,雷击,电源坏,7n60、tea1507、7n60 s极的一个二极管、保险损坏。TEA1507我们这儿有的买。

TEA1507各脚功能、tea1507维修资料,就介绍到这里啦!感谢大家的阅读!希望能够对大家有所帮助!